Van 3D print naar Carbon onderdeel!
202,989
Published 2021-02-08
This video is sponsored by Silicones & More. I used these products:
- Carbon mat: www.siliconesandmore.com/nl/koolstofweefsel-keper-…
- Epoxy: www.siliconesandmore.com/nl/sam-ht-laminating-epox…
Want to support The Practical Engineer? Get exclusive BTS and extra content:
www.patreon.com/thepracticalengineer
For more projects, build plans and other stuff:
www.thepracticalengineer.com/
Check out the gear I use and recommend here: kit.co/ThePracticalEngineer
Also check out my other social media:
Instagram: www.instagram.com/thepracticalengineer/
Facebook: www.facebook.com/emielthepracticalengineer/
Twitter: twitter.com/prctclengineer
Pinterest: nl.pinterest.com/practicalengineer
All Comments (21)
-
Nice one! Can´t wait to see where this is going. Also: Great job on the subtitles. really easy to follow along.
-
Gaaf project, heel mooi om zo lichtgewicht carbon vleugeld te maken zonder buitenmallen. Helaas is de leading edge van de rudders niet ideaal op deze manier, de lucht laat bij een kleine hoek al los. Het dikste punt moet ongeveer op 30-40 procent koorde liggen. Dat scheelt een factor 3 weerstand en 25-50 procent meer lift. De kromming moet t scherpst zijn op de neus en geleidelijk minder worden naar achter toe.
-
I'm assuming you're speaking Dutch. I love Dutch! I'm a native English speaker and can also speak German, albeit roughly. Dutch is so fun because I can understand so much of it with those other two languages under my belt! I was especially amazed when I went to the van Gogh museum in Amsterdam and could read all the signs! Awesome project, man
-
Nice! I love that you encapsulated the 3d print with the fiber. I was thinking about that recently and 3d printing would be great for one off molds vs those foam plugs traditionally used for fiberglass. Not seeing a whole lot of people doing it though oddly.
-
Yes, love the subtitles!
-
I need a pair of rudders for my hovercraft. You have inspired me to give it a go.
-
Airfoils can easily be shaped of foam with a hot wire and a wooden template on each end. This technique has been in use for decades in experimental aircraft and gives a better result.
-
Nice work
-
Prachtig materiaal
-
echt gaaf.
-
Heel cool, Benzomatic to the rescue!
-
Thank you😉
-
Mooi !!!
-
Simply Fabulous! However, I almost lost you when you put on the white jumper! Get some sun Bro!!!!!
-
Outstanding....
-
Heb je berekent hoeveel kracht op het luchtroer komt? Ik vraag mij af of je met een iets meer wall dikte en wat epoxy aan de buitenkant ook voldoende zou zijn. Al ziet dat natuurlijk niet half zo gaaf uit :p
-
This work with the carbon fiber is how the fiberglass..?
-
Hi! Could you say the ref. Of the cnc ?
-
Awesome!
-
good job
