electric gokart casero $100 dollars

If at 8:46 there were a message saying "professional driver on closed course" I would have been endlessly entertained. Great build.

Saludos Filipo tv desde México Gran talento.

Brava! Simple,and fun too.

Eres un bravo en lo q haces, mis respetos bro.

Buenos días Filipo felicitaciones una pregunta el freno de disco es de bicicleta o de motocicleta gracias otra pregunta me puedes decir las medidas largo ancho y de que diámetro son los tubos que utilizastes para el chasis gracias desde Colombia

Please let me know the name of electric device you are using to vary the voltage making it act like accelerator

Good idea brother, but your rear wheel is to far from the frame it might dent when you run fast.👍👍.

Brilliant idea using threaded studding as axle,, thanks

Приветствую. Огонь аппарат. Новых идей. Всех благ.

Beautiful work

Very nice. Please let me know about electric motor specifications. Thanks ❤

What if you use car starter motor is going to perform better or not

Me interesa mucho el tema de la transmisión, que espesor tienen el plato-corona y el piñón, para poder acoplarlo al Arranque-motor?

Que tal si colocas la lista de materiales y nos sugieres donde podríamos encontrarlos. 🤔

Nice work. What is the size of rear axle i mean diameter?

0:52 отличный узел, работающий на смазке из резьбы 😁. На полчаса его хватит

Carajo esto es villa el salvador-Perú .... Hermano genial .... Este tipo de vídeo necesitaba .... Cuánto tiempo dura con esa batería???

Great proyect, I just want to commend few possible improvements that come to my mind: 1) Without a differential or a false differential (double free wheel) perhaps it would have been better to leave one of the two rear wheels free, and not fixed to the axle, to avoid the effect of drag in curves. 2) The axis is threaded, and is leaning directly on the bearings. This causes friction, and with this occurs premature wear of both the bar and the bearing. Ideally, this section should be smooth. This axis could be adapted by adding a very fine hollow pipe on those parts. If it is not fine enough, you would have to increase the size of the bearings to achieve it. 3) It is preferable to make a screw or bolt connection to the wheel, so that the wheel can be replaced using screwdrivers or wrenches, without having to change or modify the axle. I am not clear if the axle was fixed to the wheels or only to the adaptation, if it was the second case, the reverse could unscrew the wheel. That is why it is better 3 or 4 screws that fix to a spindle end.

( RJ BRAZIL )BOA TARDE SEU TRABALHO FICOU MAGUINIFICO PARABÉNS

THIS IS ELON MUSK