[Product Review] TEKTON Manual Impact Driver
55,600
Published 2022-04-27
Replacement rotor screws: amzn.to/3EYeppx
TEKTON 3/8 Inch Drive Impact Screwdriver Set (7-Piece) | 2905 B000NPPATS
How to remove the rotor screws on a import vehicle.
I can be reached via:
👉Facebook: www.facebook.com/DIYCarModz
👉Instagram: www.instagram.com/diycarmodz
👉Email: [email protected]
👉Mailing Address:
DIYCarModz
9051 Mira Mesa Blvd 262321
San Diego, CA 92196
#tekton #diycarmodz #brakerotor #rotorscrews
All Comments (17)
-
Thank you for explaining! I did not understand how it worked until this video.
-
Saw one of these the other day work great tool
-
Most people don’t know, those screws are actually JIS (not Phillips), assuming it’s an Asian car. The bits that are included with almost all manual impacts are also JIS.
-
Good tips. Thanks
-
Thanks for this how-to. I got mine and was using it incorrectly. 👍🏻
-
Perfect! Exactly what I wanted to see! Nice demonstration with the camera.
-
great video, thanks
-
1:50 - thx so much for that infornation! :D
-
Thanks for the tip on placing the tool upside down to set it. I gave it a few good hits and the screws came loose from the rotor. A very helpful video.
-
These are NOT Phillips, these are JIS screws, that is the very reason (using the Phillips bit instead of JIS) people strip them out.
-
Has this held up over time?
-
Even better, use a JIS compatible #3 bit, such as those that Vessel sells. From the manufacturer, those are not the same Philips heads that we commonly use here in the US. You will get a much better fit with JIS. Note that JIS is no longer maintained, thus why I state it as JIS compatible.
-
Yep this is what I did, I had an impact driver, but this actually puts axial force on the screw too as it removes it. So the impact driver only impacts in the rotational direction.
-
Add some anti-seize to the screw threads and should not be hard to remove again.
-
Why i should have this? When i have impact cordless
-
I have two of these and your description did not help at all! I could not get either one to turn to right or left!