DIY Drum Sander For Drill Press | Quick Sandpaper Replacement - NO GLUE | XDIY

If you like my project, please hit the thumbs up on the video :) What do you think about the result? Write me in the comments The tools & accessories that I'm using - www.itzikdiy.com/tools-list?m=1

Getting the paper to hold onto the core was what I was trying to find a solution for. Nice work. Thanks for sharing! 😀👍

Great job, I have been wanting to make one of these for a while! Really like the use of the piece of metal to clamp the paper. Thanks for sharing! 😁

1:30 Nice magic! 😀

This press has worked like a charm for my projects youtube.com/post/UgkxajoEbapTfqWaadnqb04h6U576yxXp… . I didn't even secure it to my table top, mainly due to the fact that I was using a 15 lbs drill vise. It's not flimsy at all as to what others have claimed it to be. Make sure the locking nuts and levers are secured and there won't be any issues with light pressure and patience. I was able to drill through aluminum, plastic, and steel (steel took a while) with no problems at all. Yeah it took a little longer than a regular drill press, but I don't have the space OR the money for one.The instruction manual was worthless, but luckily assembling the press was intuitive. However, the manual would be good for ordering replacement parts if needed. There is a nice breakdown of the parts that are included in the kit. Before ordering, make sure it is compatible with your unit, it is clearly stated what models the press is compatible with.This was an excellent purchase for $40!!

Creative and inspiring people. Thank you so much

Good idea for the roundy round sander

Yes i do like your video brilliant ill get out there and make one many thanks👍👍👍👏👏👏

Super!

Great job

Bom Dia, exatamente o que eu precisa aprender, valeu !

Good idea

Молодец👍

🇧🇷 Muito bom!!

כל הכבוד 👍

It would be beneficial to add another metal strip to the opposite side of the cylinder to help balance the drum and reduce vibration.

I see that you are also a fisherman. You have so many bamboo fishing rods behind the machine. Good luck with everything!

Isn't this bad for the drill press alignment?

So when paper is done, and you have to change, the screw must be unties, and screwed in again i. The same hole. So that gives it a short timespan, becsuse the holes will not fit the screw after short amount of paper change? Perhaps some threaded insert to screw a bolt into, rather then a metal screw to wood?

I purchased a set of 4 size drums at harbor freight for 15.00.