engine run stand episode 1
13,626
Published 2022-01-26
All Comments (10)
-
Could you possibly give me the height and width please… AWESOME JOB
-
New subscriber!!!!!
-
It's probably good the Corvette is so dusty. I betcha it's covered in overspray. Been der, done dat. The stand looks like it'll work until you rev the engine too hard or if it won't idle right. Maybe a wider wheel base? IDK. My two cents.🤔
-
The trick is put the engine stand in backwards then you’ll be able to connect your engine to your stand off of your hoist same thing with taking it out and putting it in I found that to be a lot easier
-
😎
-
The test panel
-
I use 305 busted bare block marks it up like 👍 your project
-
I extended the boom on the cherry picker, and just backed the stand in between.. the other way was to offset the legs so the run parallel...
-
Why do you need a keyed ingtion switch?