Priceless Engineering // A broken antique model Peter engine crankshaft repaired by engineering work
120,030
Published 2024-07-08
#pricelessengineering
#Brokenantiquemodelcrankshaft
#Crankshaftrepairedbyengineeringwork
#Oldmodelpetterenginecrankshaft
#pkprocess
All Comments (21)
-
Great work as usual. I will be sending all my broken crankshafts to you.
-
Making crap out of scrap.
-
Они даже масляный канал не потрудились сделать! 😂
-
The world's finest crankshafts are made of weld-hardened 2 inch all-thread.
-
Видно не от хорошей жизни приходится такой ерундой заниматься. В советское время ещё были мастера, которые-бы взялись за такую работу, а сейчас врятли найдется. сразу отправят в магазин.
-
Сломалось на предыдущей сварке. Но, если нет возможности, то хоть так. Хотя понятно, что это всё колхоз недолговечный
-
Ottimo lavoro,il cliente è stato avvertito che quell'albero ha 15 minuti di garanzia? 😂😂
-
Of course, I wanted to see crankshafts at work. So, Tatra is known for its modular designs, including modular internal combustion engines, air-cooled, with prefabricated/modular crankshafts.
-
Esto no creo que funcione,es simplemente puro publicidad para que crean que esto si se puede haci por haci
-
that leaves a lot to be desired.
-
Думаю, что это делали только для видео. Поэтому оставлю комментарий, чтоб не за зря было😊
-
Super jest to zrobione pozdrawiam serdecznie i polecam ten filmik każdemu fachowcowi. 👍👍👍👍👍
-
tip top l'alignement et vas y soude tu aurais du laissez le filetage sa aurai permis de fixer la bielle dessus et l'huile aurai passer entre les filler
-
How does the big end bearing get its oil supply?
-
Eso desbastara los metales muy muy rapido.
-
Great video👏
-
il y aligne vite connaisse pas les comparateurs et le reste mais c'est il sont trop intelligent il ont même un calibre avec une jauge 👍
-
I would have liked a radius either side of the journal, maybe there is more to go, can't think a big end journal could be sized with a vernier gauge. also more care needed with protecting the crank end surfaces, these run oil seals must be good surfaces. Would have thought having the conrod present necessary to make this repair proper.
-
Cant see this working! Lost all balance.
-
Cool to see the process but isn't the heat treatment all lost when he heats it to cherry red with a torch? I've never see anyone do this to machine steel. I also wonder if they'll re-balance it.