Hyundai Elantra: How to change the gearbox oil with a manual transmission 2007, 2008, 2009, 2010
15,936
Published 2019-09-10
All Comments (18)
-
Watched your video. Got under my car. Where is drain plug? Found it. What a beech getting the filler hole nut off. Had to kick it with a wrench. Went to Dealership got 3 quarts for only 28.00.. all went well because of your video thanks
-
Awesome advises. Best so far I could find online. Thank you.
-
Thank you very much
-
Thank you!
-
Thanks, helped a lot
-
My Kia Cerato 1.6M 5-sp same identical plc as your Hyundai Elantra. Thx bro!
-
Thank you
-
Here's a tip. I have a 2007 hyundai Elantra. I figure it's better to just wait until the transmission fluid gets low and then add more through the red A/T dipstick hole with a skinny funnel then you can check the level by following the owner manual for the car and (siphon "remove") fluid with a skinny tube or add fluid as necessary and do it all through the dipstick hole. This is what I did and it worked. Just make sure you are exactly even with the HOT line on the dipstick.
-
Hi, Good Video. Very Clear. I have an i30, on top of the gearbox there is a breather. It looks oily. If I want to remove it to wash, does it unscrew or are they a push fit. Or should i leave it in place and wash with a small amount of meths (before i change the oil in the gear box)?
-
Should I just fill it up until it comes out of the input whole to know its full
-
I replaced the master cylinder on my car but now it wont catch first gear. What do u think cld be the problem?
-
Is there a filter that needs to be changed?
-
What is the size of drain and fill plug washers?
-
1:07 😂
-
Son-in-law's 2008 Hyundai Elantra is having loud whirring noise when in gear. I will try the fluid change tomorrow. How is your Hyundai manual transmission doing, so far?
-
Hi there, can I use Castrol 85w-90 GL4? Your help would be greatly appreciated. Thanks!
-
Did you reuse the washers or replace with new?
