Replacing Wheel Bearings in RV Trailer
19,333
Published 2022-05-09
All Comments (17)
-
Always tighten castle nut to 50lbs to fully seat the bearings. Then back them off
-
What a great idea that magnetic strip is and great job at replacing the bearings .
-
Thank You Sir, 1st time RV owner
-
Always spin the tire while shooting grease in the Easy Lube grease fitting.
-
Hey THANKS!!! Camping World wants $190.00 per hour form total of 6 hrs... you just saved a ton of money
-
Should have replaced races
-
Great video very cut and dry no bs
-
Great video. One thing i might add. Buy a bearing packer from hobofreight. Its impossible to hand pack a bearing. Nice video. Thanks for sharing
-
Hey, thanks for comments, especially adding any additional instructional points for the viewer.
-
Cap = the seal
-
My covers never stay on silicone?
-
I’d say for the owner needs to check their brake pads and magnet. Clean it all,remove all brake dust and scuff the brake pads with a wire brush a little
-
what's the name of that bearing remover you used to pull the bearing out ??
-
Thanks for comments
-
We lost a bearing with only 5k miles left us stranded in Nashville they made an axle overnight for us. The F-en outside bearing is to small and they revised the hub on the 6000-7000 lb axle to have a larger bearing due to this issue. Lippert should have replace these on this set of axles. Fuck Forest River and Lippert they knew this was an issue for how many years; 5 plus !!!!
-
Did it perfect until the very end. Improper use of the Lazy Lube system destroyed your brake shoes. 😢
